home *** CD-ROM | disk | FTP | other *** search
-
- HOW TO MAKE A SUPERBASE DONGLE
-
- By PARASITE of LSD. Thanx to DONGLE DOCTOR.
-
-
- THE PARTS YOU REQUIRE:
-
- 1 x Female DB-9 connector (JOYSTICK PLUG)
- 1 x 1/4 watt 100k resistor
- 1 x 1/4 watt 47k resistor
- 1 x 600v diode
- Wire
-
- Soldering iron, solder, flux, and a steady hand.
- All these parts can be purchased at any good speciaist electronics
- shop or try Maplins.
-
- ASSEMBLY:
- pin 5 (1/4 watt 100k resistor)
- pin 9 (1/4 watt 47k resistor)
- pin 2 (600v diode) (silver band points away from pins)
- pin 6 (wire) Now solder all four connections together.
-
- AND FINALLY:
- To use SUPERBASE, plug the dongle into joystick port 2.
-
- THE ALTERNATIVE:
- Get a cracked version. (I did!)
-
- NOTES ON THE PASSWORD ENTRY SYSTEM:
- This is an important message for those of you who keep personal or
- private information with a keyword entry. It's a waste of time!
-
- I got a copy of SUPERBASE from a friend who insisted on deleting some
- data files on the master disk after I had copied it, so after he had
- gone I used disk doctor to undelete the files (What a swine I turned
- out to be!). Then I found the files needed the password, oh no! I was
- beaten!, or was I ?. Using a directory utility I simply ASCII read the
- files, which gave all the information, it was not coded, which I
- expected it to be. A child could do it, (and probabely will after
- reading this!). So bad luck guys, you'll have to find a better method
- of security for your private data!
-